How to prepare your Moocall Calving Sensor before calving season begins

How to prepare your Moocall Calving Sensor before calving season begins

With calving season approaching, here's three of the key methods to prepare your Moocall Calving Sensor in advance of using the system.

 

 

Charge

Plug your sensor in for 4 to 5 hours or until the LED shows a solid green colour indicating it is fully charged.

Power On

After plugging your sensor out of the charger, you can power on by holding the button for 5 seconds. From here the LED will flash through the multicoloured sequence until the network is found, then it will flash blue intermittently.

Test

Test your sensor, by holding down the power button for one second, releasing, and holding down the button again for one second. The LED will flash green rapidly and an SMS will be sent to phones connected indicating everything is connected correctly.

 Remember, always replace the charge cap on the device before placing the sensor on a cow.

For further advice on any of the above, please contact a member of the Moocall team to speak to some of our breeding specialists on +353 1 96 96 038 or email support@moocall.com

Learn more about the Moocall Calving Sensor here: https://moocall.com/pages/moocall-calving-sensor-information

0 comments

Leave a comment